So, I have a Catalyst 6.0 80 CW 7 iron pull that I want to use for a 52 wedge. I don’t have a need for this shaft and has been sitting in my stock pile of pulls. I’m thinking about putting it I’m my 52* Vega wedge. This is a taper tip pull that was pulled from a 7 iron.
Is it ok if I tip this 1.5”, then sand down to get in a wedge? I know instructions are to but trim this shaft only, but I’m afraid if I do that, this will play really soft since it’s basically soft stepped 3 times. Again, instructions sat you shouldn’t tip trim this, but I’ve been told in the past most graphite taper tip shafts are basically tipped parallel shaft that’s been sanded down. I’ve purchased 4 iron taper tip pulls and just tip trim the appropriate amount to the corresponding iron in the past.
Is it ok if I tip this 1.5”, then sand down to get in a wedge? I know instructions are to but trim this shaft only, but I’m afraid if I do that, this will play really soft since it’s basically soft stepped 3 times. Again, instructions sat you shouldn’t tip trim this, but I’ve been told in the past most graphite taper tip shafts are basically tipped parallel shaft that’s been sanded down. I’ve purchased 4 iron taper tip pulls and just tip trim the appropriate amount to the corresponding iron in the past.