Need to lose a bit of spin....

[Joshzilla]

I am currently playing a 65g Proforce V2 stiff. Hit it on a launch monitor Saturday and launch was good, but spin was in the 3100-3200rpm range. Would a Project X take off a bit of spin? I have this shaft in my 3 wood and it performs very well for me.

Any other suggestions?

I'm looking for a different place to try/demo because the place I am going has limited availability...and in my opinion limited knowledge.

Thanks!

 

[mrvandelay]

I'm pretty sure the PF V2 is a low/mid spin shaft. What's your angle of attack?

 

[Joshzilla]

I'm pretty sure the PF V2 is a low/mid spin shaft. What's your angle of attack?

Not sure. Hitting up on the ball a little bit, but I didn't see the angle of attack on the LM data.

 

[mrvandelay]

You could try a ProLaunch Red - they're low spin and low launch and cost $50!

 

[Super Tuna]

Yup, a Red would be less. PX, Voodoo's, RIP Alpha, Speeder .1 or .2, Ahina, Devotion, Kusala Black/Indigo would all fit the bill of less spin. PL Red, PX, Speeder .1m RIP Alpha and Voodoo would keep you around the same launch angle as well. Fairly different profiles to the lot of them though

 

[Joshzilla]

Thanks guys!