Recent content by jbandalo

Like this.

Not mine. Added a rubber o-ring washer between the back weight and the club and it's so muted now, sounds like a carbon driver.

The 425 LST sounds way different compared to the max. I could not stand the sound of the max so I sold that one pronto. The 425 LST sounds much better IMO.

Sim 3 wood I’d say. If I didn’t love my G410 LST 3 wood, that would be the one I’d be looking at.

I'm the opposite now. I don't like the mushy sound of a Mavrik driver or Taylormade. I love the sound of my Ping G425 but I also have hotmelt in mine as well. Many others have commented after a hit a drive "I love the sound of that driver!". To me the worst sounding drivers are actually the...

Nope, no issues here.

One of my favorite clubs in the bag. Long and high. Funny, mine sounds just great. Not sure if true but perhaps the shaft changes the sound? Both my G425 Max driver and 5 wood have the Tensei Raw Orange shaft in them. Love them both.

Had Arccos and it was way too distracting. Had to edit every round always. Went to ShotScope and much better. Just go out and play and very little if any editing at all.

My 9* is set to -1 as well. Might even go down to -1.5 and play it at 7.5*.

I go to 5w and then 3 iron. Works great for me.

I dislike the sound of my G425 Max driver even with 3 grams of hot melt but it's as long as my G410 LST (if not longer) and quite a bit more forgiving so it's hard not to have it in the bag. Verdict is not out yet so will play it for a few more rounds before deciding.

I didn’t notice any real difference in distance. Probably the same. Worse dispersion compared to my G410 LST for me though.

If you didn't like the sound on the G400 Max, you'll definitely not like the sound of the G425 Max. That's what I tried and even with 3 grams of hot melt applied by Ping, I cringed at the sound it made every time I hit the ball with it...It's that bad and much worse than the sound of the G400...

Sticking with my G410 LST. Tried the Ping G425 briefly but that sound...no thanks.

Yup, that's what that's used for.