Recent content by airguard

Don't forget where it all started, Fisher made 4 different inserts (odyssey still pays him for it). I think the maroon had a very nice touch but also had a black that for some reason was softer than it was supposed to be.

Hope this is the correct section to post this question. Health issues have forced me to purchase an electric cart (2001 E-Z-GO TXT with roof and windshield), I now would like to purchase an enclosure for it as well. Does anyone have any suggestions? I don't want a cheap $80 cover, but have been...

Through the years my knee has taken a beating and I now have a few issues with it. I have had an MRI and a follow up with the dr, he has explained there isn't anything he can do for my knee and the pain is from a Baker's cyst, which will not go away because of the knee problems. Does anyone have...

Hope this is the right place for this. I have owned my Neo XS for about 18 months and it works great, but..... Is there any way to check the time while in the Play Mode? People see the "watch" and ask me the time, I feel a bit dumb when I have to say I don't know.:banghead: Thanks for any input.

Right handed with GS-95 regular flex shaft.

Being a bit of a putter ho I play around with counterweighting a lot. I melt lead into old shaft cut offs and install them into the putter shaft. There is a lot of add weight / take off weight involved. I am always removing and installing grips (with air). I have recently tried a Winn Jumbo Lite...

Use mine all the time, it stays mounted in one of the vises in my shop. Cut a piece of fuel hose and slip that onto the shaft for protection but wish there was a better way. Use it more just to hold clubs as I work on them rather than pulling shafts.

Yesterday pulled a Matrix HD6 shaft from an Adams Speed Line 3 wood and am installing a Aldila Rip Phenom Shaft senior flex for my wife to try. Not that she wants a 3 wood, but I had the parts so why not.

I have worked hard on my chipping and can now put it on line and usually land it "close" to where I want it but I keep coming up short. What is my mental block that I need to over come?

My wife has just started again and we are looking for a right handed name brand set of irons (5-9, PW,SW / 5h 6-9, PW, SW). We will entertain anything good. Must be willing to ship to my military APO address (zip 96531). Thanks.

Found a Wilson R20 Special Wedge for $2.00. Pulled the old brown shaft, drilled out the hosel, tapered the hosel top and polished so no furred needed. Installed a reg flex steel shaft from an old 4 iron, tipped it 4 1/2 inches, put 140 grams of lead in the butt end to counter balance the heavy...

Short story on driver length: I'm 6'1", 180 lbs, 63 yrs old, 18 handicap bouncing back from several months of a pinched sciatic nerve. I have terrible eye/hand coordination. I have been playing my R-9 (10.5*) for about 2 years now. After a few months I replaced the stock reg shaft with a stiff...

Am I confused over nothing? I have an R-11 #2 rescue that I want to replace the shaft in. As I see most hybrid shafts are .370 in dia, how do I accomadate the TM adaptor. That is how do I find a hybrid shaft that will work in the adaptor (as I undersatnd it, TM does not make a .370 adaptor...

Looking for a used shaft puller for home use, something like the Roberts. Need it sent via the USPS to my military address (San Francisco). Thanks.

I have a new, uncut Project X 5.5 (blue) shaft .335 and a new Callaway Razr Fit .335 adapter. Should the dry fit be snug or shuld the shaft go in and out freely. Mine is not snug. Thanks for any advice.